|
|
零件编号 | PIC16LF1704 | ||
描述 | 14/20-Pin 8-Bit Advanced Analog Flash Microcontrollers | ||
制造商 | Microchip | ||
LOGO | |||
1 Page
PIC16(L)F1704/8
14/20-Pin 8-Bit Advanced Analog Flash Microcontrollers
High-Performance RISC CPU
• C Compiler Optimized Architecture
• Only 49 Instructions
• Up to 14 Kbytes Linear Program Memory
Addressing
• Operating Speed:
- DC – 32 MHz
- DC – 125 ns instruction cycle
• Interrupt Capability with Automatic Context
Saving
• 16-Level Deep Hardware Stack with Optional
Overflow/Underflow Reset
• Direct, Indirect and Relative Addressing modes:
- Two full 16-bit File Select Registers (FSRs)
- FSRs can read program and data memory
• High-Endurance Flash Data Memory (HEF)
- 128 bytes of nonvolatile data storage
- 100k erase/write cycles
Flexible Oscillator Structure
• 16 MHz Internal Oscillator Block:
- Accurate to ±1%, typical
- Software selectable frequency range from
16 MHz to 250 kHz
- PLL multiplier to 32 MHz
• 31 kHz Low-Power Internal Oscillator
• External Oscillator Block with:
- Three crystal/resonator modes up to 20 MHz
- Three external clock modes up to 20 MHz
• Fail-Safe Clock Monitor:
- Allows for safe shutdown if peripheral clock
stops
• Two-Speed Oscillator Start-up
• Oscillator Start-up Timer (OST)
eXtreme Low-Power (XLP) Features
• Sleep mode: 50 nA @ 1.8V, typical
• Watchdog Timer: 500 nA @ 1.8V, typical
• Secondary Oscillator: 500 nA @ 32 kHz
• Operating Current:
- 8 µA @ 32 kHz, 1.8V, typical
- 32 µA/MHz @ 1.8V, typical
Special Microcontroller Features
• Operating Voltage Range:
- 1.8V-3.6V (PIC16LF1704/8)
- 2.3V-5.5V (PIC16F1704/8)
• Temperature Range:
- Industrial: -40°C to 85°C
- Extended: -40°C to 125°C
• Power-on Reset (POR)
• Low Power Brown-Out Reset (LPBOR)
• Extended Watch-Dog Timer (WDT):
- Programmable period from 1 ms to 256s
• Programmable Code Protection
• In-Circuit Serial Programming™ (ICSP™) via
Two Pins
• In-Circuit Debug (ICD) via Two Pins
• Enhanced Low-Voltage Programming (LVP)
• Power-Saving Sleep mode
Digital Peripheral Features
• Up to 17 I/O Pins and one Input-only Pin:
- High current sink/source for LED drivers
- Individually programmable weak pull-ups
- Interrupt-on-change pin option with edge
selectable option
• Timer0: 8-Bit Timer/Counter with 8-Bit
Programmable Prescaler
• Enhanced Timer1:
- 16-bit timer/counter with prescaler
- External Gate Input mode
- Dedicated low-power 32 kHz oscillator driver
• Timer2:
- Up to three (TMR2/4/6)
- 8-Bit Timer/Counter
- 8-Bit Period Register
- Prescaler and Postscaler
• Capture, Compare, PWM (CCP) Module
• Master Synchronous Serial Port (SSP) with SPI
and I2C with:
- 7-bit address masking
- SMBus/PMBusTM compatibility
• Enhanced Universal Synchronous Asynchronous
Receiver Transmitter (EUSART):
- RS-232, RS-485 and LIN compatible
- Auto-Baud Detect
- Auto-wake-up on Start
2013-2015 Microchip Technology Inc.
DS40001715D-page 1
PIC16(L)F1704/8
TO OUR VALUED CUSTOMERS
It is our intention to provide our valued customers with the best documentation possible to ensure successful use of your Microchip
products. To this end, we will continue to improve our publications to better suit your needs. Our publications will be refined and
enhanced as new volumes and updates are introduced.
If you have any questions or comments regarding this publication, please contact the Marketing Communications Department via
Most Current Data Sheet
To obtain the most up-to-date version of this data sheet, please register at our Worldwide Web site at:
http://www.microchip.com
You can determine the version of a data sheet by examining its literature number found on the bottom outside corner of any page.
The last character of the literature number is the version number, (e.g., DS30000000A is version A of document DS30000000).
Errata
An errata sheet, describing minor operational differences from the data sheet and recommended workarounds, may exist for current
devices. As device/documentation issues become known to us, we will publish an errata sheet. The errata will specify the revision
of silicon and revision of document to which it applies.
To determine if an errata sheet exists for a particular device, please check with one of the following:
• Microchip’s Worldwide Web site; http://www.microchip.com
• Your local Microchip sales office (see last page)
When contacting a sales office, please specify which device, revision of silicon and data sheet (include literature number) you are
using.
Customer Notification System
Register on our web site at www.microchip.com to receive the most current information on all of our products.
DS40001715D-page 8
2013-2015 Microchip Technology Inc.
PIC16(L)F1704/8
TABLE 1-3: PIC16(L)F1708 PIN OUT DESCRIPTION (CONTINUED)
Name
Function
Input Output
Type Type
Description
VSS
OUT(2)
VSS
C1OUT
Power — Ground reference.
— CMOS Comparator output.
C2OUT
— CMOS Comparator output.
CCP1
— CMOS Capture/Compare/PWM1 output.
CCP2
— CMOS Capture/Compare/PWM2 output.
PWM3OUT — CMOS PWM3 output.
PWM4OUT — CMOS PWM4 output.
COGA
COGB
— CMOS Complementary Output Generator Output A.
— CMOS Complementary Output Generator Output B.
COGC
— CMOS Complementary Output Generator Output C.
COGD
SDA(3)
— CMOS Complementary Output Generator Output D.
— OD I2C data input/output.
SDO
— CMOS SPI data output.
SCK
SCL(3)
TX/CK
— CMOS SPI clock output.
I2C OD I2C clock output.
— CMOS USART asynchronous TX data/synchronous clock output.
DT
CLC1OUT
— CMOS USART synchronous data output.
— CMOS Configurable Logic Cell 1 source output.
CLC2OUT — CMOS Configurable Logic Cell 2 source output.
CLC3OUT — CMOS Configurable Logic Cell 3 source output.
Legend: AN = Analog input or output CMOS = CMOS compatible input or output
OD = Open Drain
TTL = TTL compatible input ST = Schmitt Trigger input with CMOS levels I2C = Schmitt Trigger input with I2C
HV = High Voltage
XTAL = Crystal levels
Note 1: Default peripheral input. Input can be moved to any other pin with the PPS input selection registers. See Register 12-2.
2: All pin outputs default to PORT latch data. Any pin can be selected as a digital peripheral output with the PPS output
selection registers. See Register 12-3.
3: These I2C functions are bidirectional. The output pin selections must be the same as the input pin selections.
DS40001715D-page 16
2013-2015 Microchip Technology Inc.
|
|||
页数 | 30 页 | ||
下载 | [ PIC16LF1704.PDF 数据手册 ] |
零件编号 | 描述 | 制造商 |
PIC16LF1703 | 14/20-Pin 8-Bit Advanced Analog Flash Microcontrollers | Microchip Technology |
PIC16LF1704 | 14/20-Pin 8-Bit Advanced Analog Flash Microcontrollers | Microchip |
PIC16LF1705 | Cost-Effective 8-Bit Intelligent Analog Flash Microcontrollers | Microchip |
PIC16LF1707 | 14/20-Pin 8-Bit Advanced Analog Flash Microcontrollers | Microchip Technology |
零件编号 | 描述 | 制造商 |
STK15C88 | 256-Kbit (32 K x 8) PowerStore nvSRAM | Cypress Semiconductor |
NJM4556 | DUAL HIGH CURRENT OPERATIONAL AMPLIFIER | New Japan Radio |
EL1118-G | 5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLER | Everlight |
DataSheet8.cn | 2020 | 联系我们 | 搜索 | Simemap |