DataSheet8.cn


PDF ( 数据手册 , 数据表 ) PIC16F1619

零件编号 PIC16F1619
描述 8-Bit Flash Microcontroller
制造商 Microchip
LOGO Microchip LOGO 


1 Page

No Preview Available !

PIC16F1619 数据手册, 描述, 功能
PIC16(L)F1615/9
14/20-Pin, 8-Bit Flash Microcontroller
Description
PIC16(L)F1615/9 microcontrollers deliver on-chip features that are unique to the design for embedded control of small
motors and general purpose applications in 14/20-pin count packages. Features like 10-bit A/D, CCP, 24-bit SMT and
Zero-Cross Detection offer an excellent solution to the variety of applications. The product family also has a CRC+
memory scan and Windowed WDT to support safety-critical systems in home appliances, white goods and other end
equipment.
Core Features
• C Compiler Optimized RISC Architecture
• Only 49 Instructions
• Operating Speed:
- DC – 32 MHz clock input
- 125 ns minimum instruction cycle
• Interrupt Capability
• 16-Level Deep Hardware Stack
• One 8-Bit Timer
• Four 16-bit Timers
• Low Current Power-on Reset (POR)
• Configurable Power-up Timer (PWRT)
• Brown-out Reset (BOR) with Selectable Trip Point
• Windowed Watchdog Timer (WWDT):
- Variable prescaler selection
- Variable window size selection
- All sources configurable in hardware or
software
Memory
• 8 KW Flash Program Memory
• 1024 Bytes Data SRAM Memory
• Direct, Indirect and Relative Addressing modes
• High-Endurance Flash Data Memory (HEF):
- 128 B (nonvolatile), 100K erase/write cycles
Operating Characteristics
• Operating Voltage Range:
- 1.8V to 3.6V (PIC16LF1615/9)
- 2.3V to 5.5V (PIC16F1615/9)
• Temperature Range:
- Industrial: -40°C to 85°C
- Extended: -40°C to 125°C
eXtreme Low-Power (XLP) Features
• Sleep mode: 50 nA @ 1.8V, typical
• Watchdog Timer: 500 nA @ 1.8V, typical
• Secondary Oscillator: 500 nA @ 32 kHz
• Operating Current:
- 8 uA @ 32 kHz, 1.8V, typical
- 32 uA/MHz @ 1.8V, typical
Digital Peripherals
• Configurable Logic Cell (CLC):
- Four CLCs
- Integrated combinational and sequential logic
• Complementary Waveform Generator (CWG):
- Rising and falling edge dead-band control
- Full-bridge, half-bridge, 1-channel drive
- Multiple signal sources
• Two Capture/Compare/PWM (CCP) modules
• PWM: Two 10-bit Pulse-Width Modulators
• Two Signal Measurement Timers (SMT):
- 24-bit timer/counter with prescaler
- Multiple gate and clock inputs
• Angular Timer:
- Single pulse
- Multiple pulses with missing pulse recovery
• 8-Bit Timers (TMR2+HLT/4/6):
- Up to 3 Timer2/4/6 with Hardware Limit Timer
(HLT)
- Monitors Fault Conditions: Stall, Stop, etc.
- Multiple modes
- 8-bit timer/counter with prescaler
- 8-bit period register and postscaler
- Asynchronous H/W Reset sources
• Math Accelerator with Proportional-Integral-
Derivative (PID):
- Four operation modes
- Add and multiply
- Simple multiplier
- Multiply and Accumulate
- Programmable PID controller
• Cyclic Redundancy Check with Memory Scan
(CRC/SCAN):
- Software configurable
• Serial Communications:
- Enhanced USART (EUSART)
- SPI, I2C™, RS-232, RS-485, LIN compatible
- Auto-Baud Detect, Auto-Wake-up on start
2014-2015 Microchip Technology Inc.
Preliminary
DS40001770B--page 1







PIC16F1619 pdf, 数据表
TABLE 4: 20-PIN ALLOCATION TABLE (PIC16(L)F1619)
—— —
C1OUT
CCP1
CWG1A ZCD1OUT CLC1OUT DT(3)
OUT(2)
C2OUT
CCP2 CWG1B
— — — — CWG1C
— CLC2OUT CK
— CLC3OUT TX
—— —
— CWG1D
— CLC4OUT —
Note
1:
2:
3:
Default peripheral input. Input can be moved to any other pin with the PPS input selection registers.
All pin outputs default to PORT latch data. Any pin can be selected as a digital peripheral output with the PPS output selection registers.
These peripheral functions are bidirectional. The output pin selections must be the same as the input pin selections.
SDO
SCK(3)
PWM3OUT
PWM4OUT
——
——
——
——







PIC16F1619 equivalent, schematic
PIC16(L)F1615/9
TABLE 1-2: PIC16(L)F1615 PINOUT DESCRIPTION (CONTINUED)
Name
Function
Input
Type
Output
Type
Description
OUT(2)
C1OUT
— CMOS Comparator output.
C2OUT
— CMOS Comparator output.
CCP1
— CMOS Capture/Compare/PWM1 output.
CCP2
— CMOS Capture/Compare/PWM2 output.
PWM3OUT —
CMOS PWM3 output.
PWM4OUT —
CMOS PWM4 output.
CWG1A — CMOS Complementary Output Generator Output A.
CWG1B — CMOS Complementary Output Generator Output B.
CWG1C — CMOS Complementary Output Generator Output C.
CWG1D — CMOS Complementary Output Generator Output D.
SDO
— CMOS SPI data output.
SCK
— CMOS SPI clock output.
TX/CK
CMOS EUSART asynchronous TX data/synchronous clock
output.
DT — CMOS EUSART synchronous data output.E
CLC1OUT
CMOS Configurable Logic Cell 1 source output.
CLC2OUT
CMOS Configurable Logic Cell 2 source output.
ZCD1OUT
CMOS Zero-Cross Detect output.
VDD VDD Power — Positive supply.
VSS VSS Power — Ground reference.
Legend: AN = Analog input or output CMOS = CMOS compatible input or output
OD = Open-Drain
TTL = TTL compatible input ST = Schmitt Trigger input with CMOS levels I2C™ = Schmitt Trigger input with I2C™
HV = High Voltage
XTAL = Crystal
levels
Note 1: Default peripheral input. Input can be moved to any other pin with the PPS input selection registers.
2: All pin outputs default to PORT latch data. Any pin can be selected as a digital peripheral output with the PPS output selection
registers. See Register 13-1.
DS40001770B-page 16
Preliminary
2014-2015 Microchip Technology Inc.










页数 30 页
下载[ PIC16F1619.PDF 数据手册 ]


分享链接

Link :

推荐数据表

零件编号描述制造商
PIC16F16138-Bit Flash MicrocontrollerMicrochip
Microchip
PIC16F16148-Bit Flash MicrocontrollerMicrochip
Microchip
PIC16F16158-Bit Flash MicrocontrollerMicrochip
Microchip
PIC16F16188-Bit Flash MicrocontrollerMicrochip
Microchip

零件编号描述制造商
STK15C88256-Kbit (32 K x 8) PowerStore nvSRAMCypress Semiconductor
Cypress Semiconductor
NJM4556DUAL HIGH CURRENT OPERATIONAL AMPLIFIERNew Japan Radio
New Japan Radio
EL1118-G5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLEREverlight
Everlight


DataSheet8.cn    |   2020   |  联系我们   |   搜索  |  Simemap