|
|
零件编号 | DD-1920-HDMI | ||
描述 | HDMI INTERFACE CONTROLLER | ||
制造商 | Digital View | ||
LOGO | |||
1 Page
HDMI INTERFACE CONTROLLER
FOR TFT PANEL
Model: DD-1920-HDMI
Part number: 41730010X-3
INSTRUCTIONS
CONTENTS
Page: 2. Introduction, How to Proceed, Usage Note, Disclaimer
3. System design – Diagram of a suggested system
4. Assembly notes – Important information about system elements
5. Connection & Operation – How to use the controller
9. Connectors, pinouts & jumpers – Essential connection information
16. Controller dimensions
17. Application notes
19. Troubleshooting
20. Specifications
21. Appendix I – Mode Support Table
22. Appendix II – RS-232 control protocols
26. Appendix III – Appendix III – DDC/CI support at HDMI port
27. Appendix IV - Mapping definition
28. Appendix V – DV remote control unit work for DD-1920-HDMI
30. Warranty, Caution & Limitation of Liability, Trademarks
31. Contact details
It is essential that these instructions are read and understood before connecting or
powering up this controller.
Page 1 of 31
Sound
Mute
Mute
System
Output
[No function in this
board version]
Select audio output port
Speakers : via CN1 & J1 connector
SPDIF : via CN11 connector
Timer : OSD Timeout in seconds
3 sec
6 sec
12 sec
Always On
Rotation : OSD menu rotation in degree
0
90
180
270
Position : Adjust OSD menu position
Transparency
Press – or + (-
: Set OSD transparency
Reset : Load factory default settings.
Press down on OSD keypad to factory reset
+ ) Total : 100 steps
Remark :
Items marked have sub menus.
Exit the OSD menu to save the setting chosen
[No function in this board version]
[Firmware version : V1.07.00 or up]
Page 8 of 32
CONTROLLER DIMENSIONS
The maximum thickness of the controller is 13.95mm (measured from bottom of PCB to top of components, including any underside
components & leads). We recommend clearances of:
5mm from bottom of PCB - if mounting on a metal plate we also recommend a layer of suitable insulation material is added to the
mounting plate surface.
10mm above the components
3~5mm around the edges
Any of the holes shown above can be used for mounting the PCB, they are 3.2mm in diameter.
CAUTION: Ensure adequate insulation is provided for all areas of the PCB with special attention to high voltage parts such as the
inverter.
Page 16 of 32
|
|||
页数 | 31 页 | ||
下载 | [ DD-1920-HDMI.PDF 数据手册 ] |
零件编号 | 描述 | 制造商 |
DD-1920-HDMI | HDMI INTERFACE CONTROLLER | Digital View |
零件编号 | 描述 | 制造商 |
STK15C88 | 256-Kbit (32 K x 8) PowerStore nvSRAM | Cypress Semiconductor |
NJM4556 | DUAL HIGH CURRENT OPERATIONAL AMPLIFIER | New Japan Radio |
EL1118-G | 5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLER | Everlight |
DataSheet8.cn | 2020 | 联系我们 | 搜索 | Simemap |