|
|
零件编号 | OKI-78SR | ||
描述 | Fixed Output 1.5 Amp SIP DC/DC Converters | ||
制造商 | Murata Manufacturing | ||
LOGO | |||
1 Page
www.murata-ps.com
OKI-78SR Serieswww.DataSheet4U.com
Fixed Output 1.5 Amp SIP DC/DC Converters
Typical unit
FEATURES
■ Ultra wide 7 to 36 VDC input range
■ Fixed Outputs of 3.3 or 5 VDC up to 1.5 Amps
■ Vertical SIP-mount, small footprint package
■ “No heat sink” direct replacement for 3-terminal
78xx-series linear regulators
■ High efficiency with no external components
■ Short circuit protection
■ Outstanding thermal derating performance
■ UL/EN/IEC 60950-1, 2nd Edition safety approvals
(pending)
PRODUCT OVERVIEW
Fabricated on a 0.41 by 0.65 inch (10.4 by 16.5
mm) Single Inline Package (SIP) module, the OKI-
78SR series are non-isolated switching regulator
(SR) DC/DC power converters for embedded ap-
plications. The fixed single output converters offer
both tight regulation and high efficiency directly
at the power usage site and are a direct plug-in
replacement for TO-220 package 78xx series linear
regulators. Typically, no extra outside components
are required.
Two nominal output voltages are offered (3.3
and 5 VDC), each with 1.5 Amp maximum output.
Based on fixed-frequency buck switching topology,
the high efficiency means very low heat and little
electrical noise, requiring no external components.
The ultra wide input range is 7 to 36 Volts DC.
Protection features include input undervoltage
and short circuit protection, overcurrent and over
temperature shut down. The OKI-78SR is designed
to meet all standards approvals. RoHS-6 (no lead)
hazardous material compliance is specified as
standard.
Contents
Description, Connection Diagram, Photograph
Ordering Guide, Model Numbering, Product Labeling
Mechanical Specifications, Input/Output Pinout
Detailed Electrical Specifications
Performance Data and Oscillograms
Soldering Guidelines, Application Notes
Page
1
2
3
4
5
9
+Vin
F1
External
DC
Power
Source
Connection Diagram
Controller
t4XJUDIJOH
t'JMUFST
t$VSSFOU4FOTF
Reference and
Error Amplifier
+Vout
Common
Figure 1. OKI-78SR
Note: Murata Power Solutions strongly recommends an external input fuse, F1.
See specifications.
Common
For full details go to
www.murata-ps.com/rohs
www.murata-ps.com
email: [email protected]
21 May 2010 MDC_OKI-78SR-W36.A01 Page 1 of 10
OKI-78SR Serieswww.DataSheet4U.com
Fixed Output 1.5 Amp SIP DC/DC Converters
PERFORMANCE DATA – OKI-78SR5/1.5-W36
Step Load Transient Response (Vin=7V, Vout=nominal, Cload=0, Iout=0.75A to 1.5A,
Slew=1A/μS, Ta=+25˚C.) Trace 2=Vout, 100 mV/div. Trace 4=Iout, 0.5A/div.
Step Load Transient Response (Vin=7V, Vout=nominal, Cload=0, Iout=1.5A to 0.75A,
Slew=1A/μS, Ta=+25˚C.) Trace 2=Vout, 100 mV/div. Trace 4=Iout, 0.5A/div.
Step Load Transient Response (Vin=12V, Vout=nominal, Cload=0, Iout=0.75A to 1.5A,
Slew=1A/μS, Ta=+25˚C.) Trace 2=Vout, 100 mV/div. Trace 4=Iout, 0.5A/div.
Step Load Transient Response (Vin=12V, Vout=nominal, Cload=0, Iout=1.5A to 0.75A,
Slew=1A/μS, Ta=+25˚C.) Trace 2=Vout, 100 mV/div. Trace 4=Iout, 0.5A/div.
Step Load Transient Response (Vin=36V, Vout=nominal, Cload=0, Iout=0.75A to 1.5A,
Slew=1A/μS, Ta=+25˚C.) Trace 2=Vout, 100 mV/div. Trace 4=Iout, 0.5A/div.
Step Load Transient Response (Vin=36V, Vout=nominal, Cload=0, Iout=1.5A to 0.75A,
Slew=1A/μS, Ta=+25˚C.) Trace 2=Vout, 100 mV/div. Trace 4=Iout, 0.5A/div.
www.murata-ps.com
email: [email protected]
21 May 2010 MDC_OKI-78SR-W36.A01 Page 8 of 10
|
|||
页数 | 10 页 | ||
下载 | [ OKI-78SR.PDF 数据手册 ] |
零件编号 | 描述 | 制造商 |
OKI-78SR | Fixed Output 1.5 Amp SIP DC/DC Converters | Murata Manufacturing |
零件编号 | 描述 | 制造商 |
STK15C88 | 256-Kbit (32 K x 8) PowerStore nvSRAM | Cypress Semiconductor |
NJM4556 | DUAL HIGH CURRENT OPERATIONAL AMPLIFIER | New Japan Radio |
EL1118-G | 5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLER | Everlight |
DataSheet8.cn | 2020 | 联系我们 | 搜索 | Simemap |