DataSheet8.cn


PDF ( 数据手册 , 数据表 ) GR-AX970

零件编号 GR-AX970
描述 (GR-SXMxx0 / GR-AX970) Compact VHS Camcorder
制造商 JVC
LOGO JVC LOGO 


1 Page

No Preview Available !

GR-AX970 数据手册, 描述, 功能
INSTRUCTIONS
www.DataSheet4U.com
ENGLISH
COMPACT VHS CAMCORDER
GR-SXM740
GR-SXM340
GR-SXM240
GR-AX970
LYT0880-001C
For Customer Use:
Enter below the Model No. and Serial No. which is
located on the bottom of the camcorder. Retain this
information for future reference.
Model No.
Serial No.
S-VHS is compatible with
GR-SXM740/SXM540/
SXM340/SXM240 only
* *U
Printed in Malaysia
1101MKV UN PJ
COPYRIGHT© 2001 VICTOR COMPANY OF JAPAN, LTD
Dear Customer,
Thank you for purchasing the JVC Compact VHS camcorder. Before use, please read
PRECAUTIONS(pg. 3, 4) to ensure safe use of this product.
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO MODE” is set to “ON”
(factory-preset).
• Available when the Power Switch @ is set to “ ” or “ ”.
• Performing any operation during the demonstration stops the demonstration temporarily. If no operation
is performed for more than 1 minute after that, the demonstration will resume.
• “DEMO MODE” remains “ON” even if the camcorder power is turned off.
• To cancel Automatic Demonstration, set the Power Switch @ to “ ” and press the MENU Wheel 1 in
while the demo is in progress. This takes you directly to the demo mode’s Setting Menu (so you will not
have to go through the main Menu Screen). Rotate the MENU Wheel 1 to select “OFF” and press it.
NOTES: www.DataSheet4U.com
• When a tape whose Erase Protection tab is in the position that allows recording is loaded in the
camcorder, demonstration is not available.
• If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration
activated on the LCD monitor* or viewfinder.
* Applicable models only.
1







GR-AX970 pdf, 数据表
Grip Adjustment
www.DataSheet4U.com
1) Separate the Velcro strip.
2) Pass your right hand through the loop and grasp
the grip.
3) Adjust so that your thumb and fingers can easily
operate the Recording Start/Stop Button ! and
Power Zoom Lever 3. Refasten the Velcro strip.
3
!
Tripod Mounting
Align the screw and camera direction stud on the
tripod with the tripod mounting socket W. Then
tighten the screw.
CAUTION
When using a tripod, be
sure to open and extend
its legs fully to stabilize
the camcorder. To
prevent damage to the
unit caused by falling
over, do not use a
small-sized tripod.
Viewfinder Adjustment
1) Set the Power Switch @ to “ ” or “ ”.
2) Turn the Diopter Adjustment Control o until the
indications in the viewfinder are clearly focused.
180°
PAUSE
Shoulder Strap Attachment
Thread the strap through the eyelet y, then fold it
back and thread it through the buckle. Repeat the
procedure to attach the other end of the strap to
the other eyelet y, making sure the strap is not
twisted. Adjust the length.
www.DataSheet4U.com
y
Loading/Unloading A Cassette
1) Open the LCD monitor fully*. Slide EJECT t
until the cassette holder opens. Do not use force
to open.
q2) Insert or remove a cassette. When inserting,
make sure the label is facing outward.
appears when a cassette is loaded.
3) Press the Close button i to close the cassette
holder until it locks into place. Close the LCD
monitor*.
Closing the LCD monitor while the cassette holder is
still open may cause damage to the LCD monitor*.
Make sure the erase protection tab is in the position
that allows recording. If not, slide the tab. Some
cassettes have removable tabs. If the tab has been
removed, cover the hole with adhesive tape.
The cassette holder cannot be opened while the
camcorder is in the record mode or detached from
the power source.
* Applicable models only.
Cassette holder
t
Gear
Turn to
take up
slack.
i
Erase
Protection tab
t
Cassette
holder
i
8







GR-AX970 equivalent, schematic
Using The Cassette Adapter
www.DataSheet4U.com
Use this to play back an S-VHS-C/VHS-C video
cassette recorded with this camcorder on a S-VHS/
VHS VCR.
1) Slide the battery cover up to remove it, install
one AA (R6)size battery, then reattach the
cover.
2) Slide the latch to open the compartment door,
then insert the cassette and close the
compartment door.
3) Load the cassette adapter into the VCR and
play the tape back.
4) Slide the latch and the compartment door opens
automatically. This may take around 10 seconds.
Do not attempt to force the adapter open. Then,
insert your finger in the hole, and push up and
remove the cassette.
During tape loading and unloading, do not touch
the reels for safety and tape protection.
Tapes recorded in S-VHS or S-VHS ET mode
cannot be played back on a regular VHS VCR.
Playback is possible with a VCR equipped with
the S-VHS or SQPB (S-VHS QUASI PLAYBACK)
function (GR-SXM740/SXM540/SXM340/SXM240
only).
During special-effect playback (slow motion, still
frame, etc.), the picture may vibrate or noise bars
may appear on the screen.
To record on a VCR using a compact cassette
and the adapter, cover the adapters recording
safety hole with adhesive tape.
Connection To A Personal Computer
(GR-SXM740/SXM340 only)
You can transfer image data from the camcorder to
a PC using Digital Photo Navigator. When
connecting to your PC, refer to the instruction
manuals of the PC and Setup Guide for the
provided software.
When connecting to a Macintosh . . .
The optional KEYSPAN USA-19 USB PDA
Adapter is required.
Macintosh is a registered trademark of Apple
Computer, Inc.
Keyspan is a trademark of InnoSys Inc.
Sliding Latch
Compartment Door
Recording
Safety Hole
Hole
Battery Cover
Reels
www.DataSheet4U.com
16










页数 30 页
下载[ GR-AX970.PDF 数据手册 ]


分享链接

Link :

推荐数据表

零件编号描述制造商
GR-AX970(GR-SXMxx0 / GR-AX970) Compact VHS CamcorderJVC
JVC

零件编号描述制造商
STK15C88256-Kbit (32 K x 8) PowerStore nvSRAMCypress Semiconductor
Cypress Semiconductor
NJM4556DUAL HIGH CURRENT OPERATIONAL AMPLIFIERNew Japan Radio
New Japan Radio
EL1118-G5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLEREverlight
Everlight


DataSheet8.cn    |   2020   |  联系我们   |   搜索  |  Simemap