|
|
零件编号 | IW4541B | ||
描述 | Programmable Timer | ||
制造商 | IK Semiconductor | ||
LOGO | |||
1 Page
TECHNICAL DATA
IW4541B
Programmable Timer
High-Performance Silicon-Gate CMOS
The IW4541B programmable timer consists of a 16-stage binary
counter, an oscillator that is controlled by external R-C components (2
resistors and a capacitor), an automatic power-on reset circuit, and output
control logic. The counter increments on positive-edge clock transitons
and can also be reset via the MASTER RESET input.
The output from this timer is the Q or not Q output from the 8th, 10th,
13th, or 16th counter stage. The desired stage is chosen using time-select
inputs A and B. The output is available in either of two modes selectable
via the MODE input, pin 10. When this MODE input is a logic “1”,the
output will be a continuous square wave having a frequency equal to the
oscillator frequency divided by 2N. With the MODE input set to logic ”0” ORDERING INFORMATION
and after a MASTER RESET is initiated, the output (assuming Q output
has been selected) changes from a low to a high state after 2N-1 counts and
IW4541BN Plastic
IW4541BD SOIC
remains in that state until another MASTER RESET pulse is applied or TA = -55° to 125° C for all packages
the MODE input is set to a logic “1”.
Timing is initialized by setting the AUTO RESET input (pin 5) to
logic “0”and turning power on. If pin 5 is set to logic “1”, the AUTO RESET circuit is disabled and counting will not
start untill after a positive MASTER RESET pulse is applied and returns to a low level. The AUTO RESET consumes
an appreciable amount of power and should not be used if low-power operation is desired. For reliable automatic
power-on reset, VCC should be greater than 5V.
• Operating Voltage Range: 3.0 to 18 V
• Maximum input current of 1 µA at 18 V over full package-temperature range; 100 nA at 18 V and 25°C
• Noise margin (over full package temperature range):
1.0 V min @ 5.0 V supply
2.0 V min @ 10.0 V supply
2.5 V min @ 15.0 V supply
LOGIC DIAGRAM
PIN ASSIGNMENT
t4u.comPIN 14 =VCC
e PIN 7 = GND
www.datashePINS 4,11 = NO CONNECTION
NC = NO CONNECTION
1
|
|||
页数 | 6 页 | ||
下载 | [ IW4541B.PDF 数据手册 ] |
零件编号 | 描述 | 制造商 |
IW4541B | Programmable Timer | IK Semiconductor |
零件编号 | 描述 | 制造商 |
STK15C88 | 256-Kbit (32 K x 8) PowerStore nvSRAM | Cypress Semiconductor |
NJM4556 | DUAL HIGH CURRENT OPERATIONAL AMPLIFIER | New Japan Radio |
EL1118-G | 5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLER | Everlight |
DataSheet8.cn | 2020 | 联系我们 | 搜索 | Simemap |