DataSheet8.cn


PDF ( 数据手册 , 数据表 ) ZNBG3011

零件编号 ZNBG3011
描述 FET BIAS CONTROLLER AND POLARITY SWITCH
制造商 Zetex Semiconductors
LOGO Zetex Semiconductors LOGO 


1 Page

No Preview Available !

ZNBG3011 数据手册, 描述, 功能
FET BIAS CONTROLLER AND
POLARITY SWITCH
ISSUE 1 - FEBRUARY 1998
DEVICE DESCRIPTION
The ZNBG series of devices are designed to
meet the bias requirements of GaAs and
HEMT FETs commonly used in satellite
receiver LNBs, PMR cellular telephones etc.
with a minimum of external components.
With the addition of two capacitors and a
resistor, the devices provide drain voltage
and current control for three external
grounded source FETs, generating the
regulated negative rail required for FET gate
biasing whilst operating from a single supply.
This negative bias, at -3 volts, can also be
used to supply other external circuits.
The ZNBG3010/11 includes bias circuits to
drive up to three external FETs. A control
input to the device selects either one of two
FETs as operational, the third FET is
permanently active. This feature is
particularly used as an LNB polarisation
switch.
Drain current setting of the ZNBG3010/11 is
user selectable over the range 0 to 15mA,
this is achieved with addition of a single
resistor. The series also offers the choice of
drain voltage to be set for the FETs, the
ZNBG3010 gives 2.2 volts drain whilst the
ZNBG3011 gives 2 volts.
FEATURES
Provides bias for GaAs and HEMT FETs
Drives up to three FETs
Dynamic FET protection
Drain current set by external resistor
Regulated negative rail generator
requires only 2 external capacitors
Choice in drain voltage
Wide supply voltage range
Polarisation switch for LNBs
QSOP surface mount package
ZNBG3010
ZNBG3011
These devices are unconditionally stable
over the full working temperature with the
FETs in place, subject to the inclusion of the
recommended gate and drain capacitors.
These ensure RF stability and minimal
injected noise.
It is possible to use less than the devices full
complement of FET bias controls, unused
drain and gate connections can be left open
circuit without affecting operation of the
remaining bias circuits.
In order to protect the external FETs the
circuits have been designed to ensure that,
under any conditions including power
up/down transients, the gate drive from the
bias circuits cannot exceed the range -3.5V
to 1V. Furthermore if the negative rail
experiences a fault condition, such as
overload or short circuit, the drain supply to
the FETs will shut down avoiding excessive
current flow.
The ZNBG3010/11 are available in QSOP16
for the minimum in device size. Device
operating temperature is -40 to 70°C to suit
a wide range of environmental conditions.
APPLICATIONS
Satellite receiver LNBs
Private mobile radio (PMR)
Cellular telephones
4-114







ZNBG3011 pdf, 数据表
ZNBG3010
ZNBG3011
APPLICATIONS INFORMATION (Continued)
The following block diagram shows the main section of an LNB designed for use with the Astra
series of satellites. The ZNBG3010/11 is the core bias and control element of this circuit. The
ZNBG provides the negative rail, FET bias control and polarisation switch control, with the
minimum of external components. Compared to other discrete component solutions the ZNBG
circuit reduces component count and overall size required.
Single Standard/ Enhanced LNB block diagram.
4-121














页数 10 页
下载[ ZNBG3011.PDF 数据手册 ]


分享链接

Link :

推荐数据表

零件编号描述制造商
ZNBG3010FET BIAS CONTROLLER AND POLARITY SWITCHZetex Semiconductors
Zetex Semiconductors
ZNBG3010Q16FET BIAS CONTROLLER AND POLARITY SWITCHZetex Semiconductors
Zetex Semiconductors
ZNBG3011FET BIAS CONTROLLER AND POLARITY SWITCHZetex Semiconductors
Zetex Semiconductors
ZNBG3011Q16FET BIAS CONTROLLER AND POLARITY SWITCHZetex Semiconductors
Zetex Semiconductors

零件编号描述制造商
STK15C88256-Kbit (32 K x 8) PowerStore nvSRAMCypress Semiconductor
Cypress Semiconductor
NJM4556DUAL HIGH CURRENT OPERATIONAL AMPLIFIERNew Japan Radio
New Japan Radio
EL1118-G5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLEREverlight
Everlight


DataSheet8.cn    |   2020   |  联系我们   |   搜索  |  Simemap