DataSheet8.cn


PDF ( 数据手册 , 数据表 ) VP101-3BAHP

零件编号 VP101-3BAHP
描述 30/50MHz 8-BIT CMOS VIDEO DAC
制造商 Zarlink Semiconductor Inc
LOGO Zarlink Semiconductor Inc LOGO 


1 Page

No Preview Available !

VP101-3BAHP 数据手册, 描述, 功能
www.DataSheet4U.com
THIS DOCUMENT IS FOR MAINTENANCE
PURPOSES ONLY AND IS NOT
RECOMMENDED FOR NEW DESIGNS
www.DataSheet4U.com
www.DataSheet4U.com







VP101-3BAHP pdf, 数据表
www.DataSheet4U.com
PCB LAYOUT CONSIDERATIONS
To obtain the optimum performance from the VP101
great care must be taken in the PCB layout to ensure low
noise power and ground lines. This can be achieved by
shielding the digital inputs and providing good decoupling.
Power and Ground Planes
The VP101 and its associated circuitry should have its
own power/ground planes connected at a single point
through a ferrite bead. It is important that the regular PCB
and ground planes do not overlay any portions of the analog
power or ground planes to minimise plane-to-plane noise
coupling.
Digital Signal Interconnect
The digital signal lines to the VP101 should be isolated
as much as possible from the analog circuitry. Due to the
high clock rates used, the clock lines to the VP101 should be
as short as possible to minimise noise pickup.
Any pull-up resistors used on the inputs should be
connected to the regular PCB power plane, not to the analog
power plane.
VP101
Supply Decoupling
Noise on the analog power plane will be further reduced
by the use of multiple decoupling capacitors (See Fig. 5).
Optimum performance is obtained with 0.1µF chip
ceramic capacitors placed as close as possible to the VAA
pins, with the shortest leads possible to reduce lead
inductance.
It should be noted that while the loop amplifier circuitry
of the VP101 will reject power supply noise, this rejection
decreases with frequency. Any high frequency noise on the
regular supply (such as produced by a switch mode power
supplies) must be adequately suppressed, else the designer
should consider using a three terminal regulator to supply
the analog power plane.
Analog Signal Interconnect
For optimum performance the analog output connectors
and source termination resistors should be as close as
possible to the VP101 to minimise noise pickup and
reflections due to impedance mismatch. The video out
signals should overlay the ground plane and not the analog
power plane, to maximise the high frequency power supply
rejection.
www.DataSheet4U.com
Fig.5 VP101 typical connections
7
www.DataSheet4U.com














页数 10 页
下载[ VP101-3BAHP.PDF 数据手册 ]


分享链接

Link :

推荐数据表

零件编号描述制造商
VP101-3BAHP30/50MHz 8-BIT CMOS VIDEO DACZarlink Semiconductor Inc
Zarlink Semiconductor Inc

零件编号描述制造商
STK15C88256-Kbit (32 K x 8) PowerStore nvSRAMCypress Semiconductor
Cypress Semiconductor
NJM4556DUAL HIGH CURRENT OPERATIONAL AMPLIFIERNew Japan Radio
New Japan Radio
EL1118-G5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLEREverlight
Everlight


DataSheet8.cn    |   2020   |  联系我们   |   搜索  |  Simemap