DataSheet8.cn


PDF ( 数据手册 , 数据表 ) DCR012405U1K

零件编号 DCR012405U1K
描述 Miniature/ 1W Isolated REGULATED DC/DC CONVERTERS
制造商 Burr-Brown Corporation
LOGO Burr-Brown Corporation LOGO 


1 Page

No Preview Available !

DCR012405U1K 数据手册, 描述, 功能
®
For most current data sheet and other
product information, visit www.burr-brown.com
DCR01
DCR01
DCR01
Series
Miniature, 1W Isolated
REGULATED DC/DC CONVERTERS
FEATURES
q UL1950 RECOGNIZED
q PDIP-18, SO-28(1)
q 53W/in3 (3.3W/cm3) POWER DENSITY
q DEVICE-TO-DEVICE SYNCHRONIZATION
q THERMAL PROTECTION
q 1000Vrms ISOLATION
q 400kHz SWITCHING
q 125 FITS AT 55°C
q ±10% INPUT RANGE
q SHORT-CIRCUIT PROTECTED
q 5V, 12V, 24V INPUTS
q 3.3V, 5V OUTPUTS
q HIGH EFFICIENCY
APPLICATIONS
q POINT-OF-USE POWER CONVERSION
q DIGITAL INTERFACE POWER
q GROUND LOOP ELIMINATION
q POWER-SUPPLY NOISE REDUCTION
DESCRIPTION
DCR01 family is a series of high-efficiency, input-
isolated, output-regulated DC/DC converters. In addi-
tion to 1W nominal, galvanically-isolated output power
capability, this range of DC/DCs offer very low out-
put noise, thermal protection and high accuracy.
The DCR01 family is implemented in standard molded
IC packaging, giving standard JEDEC outlines suit-
able for high-volume assembly.
The DCR01 is manufactured using the same technol-
ogy as standard IC packages, thereby achieving very
high reliability.
NOTE: (1) SO version available Q3 2000.
SYNC
VS
Input
Controller
VREC
LDO
Regulator
ENABLE
ERROR
VOUT
0V 0V
International Airport Industrial Park • Mailing Address: PO Box 11400, Tucson, AZ 85734 • Street Address: 6730 S. Tucson Blvd., Tucson, AZ 85706 • Tel: (520) 746-1111
Twx: 910-952-1111 • Internet: http://www.burr-brown.com/ • Cable: BBRCORP • Telex: 066-6491 • FAX: (520) 889-1510 • Immediate Product Info: (800) 548-6132
©2000 Burr-Brown Corporation
PDS-1587A
Printed in U.S.A. May, 2000







DCR012405U1K pdf, 数据表
pulled low, the DCR01 will be disabled. The disable time
depends upon the external loading. The internal disable
function is implemented in 2µs. Removal of the pull down
will enable the DCR01.
Capacitance loading on the SYNC pin should be minimized
in order to prevent a reduction in the internal oscillator‘s
frequency. See Application Bulletin AB-153 External Syn-
chronization of the DCP01/02 Series of DC/DC Converters.
This document contains information on how to null the
effects of additional capacitance on the sync pin. The oscil-
lators frequency can be measured at VREC, as this is the
fundamental frequency of the ripple component.
OUTPUT ENABLE/DISABLE
The regulated output of the DCR01 can be disabled by
pulling the ENABLE pin low. Holding the ENABLE pin
high enables the regulated output voltage, thus allowing the
output to be controlled from the isolated side.
ERROR FLAG
The DCR01 has an Error pin which provides a ‘power good’
flag, as long as the internal regulator is in regulation.
DECOUPLING
Ripple Reduction
Due to the very low forward resistance of the DMOS
switching transistors, high current demands are placed upon
the input supply for a short time. By using a good quality
low Equivalent Series Resistance (ESR) capacitor of 2.2µF
(minimum) for the 5V input devices and a 0.47µF capacitor
for the 12V and 24V devices, placed close to the IC supply
input pins, the effects on the power supply can be mini-
mized.
The high switching frequency of 400kHz allows relatively
small values of capacitors to be used for filtering the recti-
fied output voltage. A good quality low ESR capacitor of
1µF placed close to the VREC pin and output ground will
reduce the ripple.
It is not recommended that the DCR01 be fitted using an
IC socket as this will degrade performance.
The output at VREC is full wave rectified and produces a
ripple of 800kHz.
It is recommended that a 0.1µF low ESR capacitor is
connected close to the output pin and ground to reduce noise
on the output. The capacitor values listed are minimum
values. If lower ripple is required then the filter capacitor
should be increased in value to 0.47µF.
NOTE: As with all switching power supplies the best
performance is only obtained with low ESR capacitors
connected close to the switcher. If low ESR capacitors are
not used, the ESR will generate a voltage drop when the
capacitor is supplying the load power. Often a larger capaci-
tor is chosen for this purpose when a low ESR smaller
capacitance would perform as well.
PCB LAYOUT
RIPPLE AND NOISE
Careful consideration should be given to the layout of the
PCB in order for the best results to be obtained.
The DCR01 is a switching power supply and as such can
place high peak current demands on the input supply. In
order to avoid the supply falling momentarily during the fast
switching pulses, ground and power planes should be used
to track the power to the input of DCR01, this will also serve
to reduce noise on the circuit. If this is not possible, the
supplies must be connected in a star formation, with the
tracks made as wide as possible.
If the SYNC pin is being used, the tracking between device
SYNC pins should be short to avoid stray capacitance. If the
SYNC pin is not being used it is advisable to place a guard
ring (connected to input ground) around this pin to avoid any
noise pick up.
The output should be taken from the device using ground
and power planes. This will ensure minimum losses.
A good quality low ESR capacitor placed as close as
practicable across the input will reduce reflected ripple and
ensure a smooth start up.
A good quality low ESR capacitor placed as close as
practicable across the rectifier output terminal and output
ground will give the best ripple and noise performance.
THERMAL MANAGEMENT
Due to the high power density of this device, it is advisable
to provide a ground plane on the output. The output regula-
tor is mounted on a copper leadframe, and a ground plane
will serve as an efficient heatsink.
®
DCR01
8














页数 9 页
下载[ DCR012405U1K.PDF 数据手册 ]


分享链接

Link :

推荐数据表

零件编号描述制造商
DCR012405U1KMiniature/ 1W Isolated REGULATED DC/DC CONVERTERSBurr-Brown Corporation
Burr-Brown Corporation

零件编号描述制造商
STK15C88256-Kbit (32 K x 8) PowerStore nvSRAMCypress Semiconductor
Cypress Semiconductor
NJM4556DUAL HIGH CURRENT OPERATIONAL AMPLIFIERNew Japan Radio
New Japan Radio
EL1118-G5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLEREverlight
Everlight


DataSheet8.cn    |   2020   |  联系我们   |   搜索  |  Simemap