|
|
零件编号 | TM070DVHG01 | ||
描述 | TFT+TP MODULE | ||
制造商 | Tianma | ||
LOGO | |||
1 Page
Model No.TM070DVHG01
MODEL NO. :
ISSUED DATE:
VERSION :
TM070DVHG01
2015-02-02
V1.4
■Preliminary Specification
□Final Product Specification
Customer :
Approved by
Notes
TIANMA Confirmed :
Prepared by
Checked by
Approved by
This technical specification is subjected to change without notice
The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation
and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of
TIANMA MICRO-ELECTRONICS Corporation.
Page 1 of 27
4 Electrical Characteristics
4.1 .1Driving TFT LCD Panel
Model No.TM070DVHG01
Item
Digital Supply
Voltage
Analog Supply
Voltage
Gate On Voltage
Symbol
VDD
AVDD
VGH
Min
3.0
10.8
15.7
Typ
3.3
11.0
16.0
Max
3.6
11.2
16.3
Unit
V
V
V
Remark
Gate Off Voltage VGL -7.1 -6.8 -6.5 V
Common Electrode VCOM 3.45 3.55 3.65 V With the VR Knob
Driving Signal
Table 4.1 LCD module electrical characteristics
Note1: For different LCM, the value may have a bit of difference.
Ta = 25℃
4.1.2 TFT Driving Backlight
Item
Forward Current
Forward Voltage
Operating Life Time
Symbol
IF
VF
Condition
-
-
Min
120
9.3
Typ
-
-
- 15000 - -
Table 4.2 LED backlight characteristics
Max Unit Remark
mA V 18 LEDs
(3 LED
V mA Serial, 6
Hrs
mW
LED
Parallel)
Note1: The LED driving condition is defined for each LED module (3 LED Serial, 6 LED Parallel).For
each LED: IF (1/6) =20mA, VF (1/3) =3.3V.
Note2: Under LCM operating, the stable forward current should be inputted. And forward voltage is
for reference only.
Note3: IF is defined for one channel LED. Optical performance should be evaluated at Ta=25℃ only
If LED is driven by high current, high ambient temperature & humidity condition. The life time of LED
will be reduced. Operating life means brightness goes down to 50% initial brightness. Typical
operating life time is estimated data.
.
The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation
and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of
TIANMA MICRO-ELECTRONICS Corporation.
Page 8 of 27
Model No.TM070DVHG01
Note 1: Definition of optical measurement system.
The optical characteristics should be measured in dark room. After 5 Minutes operation, the optical
properties are measured at the center point of the LCD screen. All input terminals LCD panel must
be ground when measuring the center area of the panel.
Photo detector
Field
TFT-LCD Module
500mm
LCD Panel
Item
Contrast Ratio
Luminance
Chromaticity
Lum Uniformity
Response Time
Photo detector Field
SR-3A
1°
BM-7A
2°
The center of the screen
Note 2: Definition of viewing angle range and measurement system.
viewing angle is measured at the center point of the LCD by CONOSCOPE(ergo-80)。
Note 3: Definition of contrast ratio
―White state ―: The state is that the LCD should drive by Vwhite.
―Black state‖: The state is that the LCD should drive by Vblack.
The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation
and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of
TIANMA MICRO-ELECTRONICS Corporation.
Page 16 of 27
|
|||
页数 | 27 页 | ||
下载 | [ TM070DVHG01.PDF 数据手册 ] |
零件编号 | 描述 | 制造商 |
TM070DVHG01 | TFT+TP MODULE | Tianma |
零件编号 | 描述 | 制造商 |
STK15C88 | 256-Kbit (32 K x 8) PowerStore nvSRAM | Cypress Semiconductor |
NJM4556 | DUAL HIGH CURRENT OPERATIONAL AMPLIFIER | New Japan Radio |
EL1118-G | 5 PIN LONG CREEPAGE SOP PHOTOTRANSISTOR PHOTOCOUPLER | Everlight |
DataSheet8.cn | 2020 | 联系我们 | 搜索 | Simemap |